The Wolverine stack is the classic two-peptide pairing of BPC-157 and TB-500, combined in a single vial and drawn together. Both are widely studied in soft-tissue and recovery research contexts, which is why they're so often paired. Vial sizes and ratios vary by source. A 1:1 mass pairing is common (for example 5 mg / 5 mg or 10 mg / 10 mg), so enter your actual vial amounts rather than assuming a fixed total.
Unlike the GLOW and KLOW skin blends, the Wolverine pairing is usually close to balanced, so you can anchor on either compound and confirm the other in the same draw. Set your target dose for the lead peptide; the calculator returns the syringe draw and the per-component mass so you know exactly what each injection delivers.
Pick the bacteriostatic water volume that makes your target dose land on a clean, readable syringe mark. The calculator solves the BAC water for you, reports the resulting concentration, and verifies the mass of both peptides per draw, so a single co-draw delivers each at the dose you intended.
PepRecon is a research and education resource. This page is for informational and laboratory-research purposes only. It is not medical advice, is not a recommendation to use any compound, and is not for human consumption. Several peptides discussed here are not FDA-approved and their regulatory status can change. Consult a licensed healthcare provider before making any decision. Always use sterile technique. Calculations run entirely in your browser and are not transmitted or stored unless you generate a share link.